RC Modelling

Recently I have resurected my RC electric car. It resebles the 2 generations old Porsche GT3. It runs on an electric battery and should be able to do 30-40 km/h. It was a rainy day and I had to manage something so that water would not reach the engine and the wires. I used a plastic bag. I cut it into half and used cello tape in order to wrap it around the chasis. This wored quite well until I hit a deep puddle, where a stone cut through the plastic bag armour. The isea was good but lacks development. After I dry out every bit a reassemble the car again I will try to use something stronger in order to stop the water next time, especially because winter will be here soon. Perhaps cotton with thicker plastic might work. However it will be difficult to stop the water entering through the wheel archs. Cello taping the exit might work. The next launch will be at the begining of october.